So I needed a brush & razor holder when I picked up my setup intially.
I've always liked wood, but the options were limited and I picked up the Col Conks one from Amazon.
While it works, the rear trench for the razor wasn't big enough, and I'd wanted it on a tilt to better keep the razor in place.
So without further ado, I set out to match what came in the mail, from some fallen cedars in my yard.
A bit chunkier, but I think it does the trick.
If I had a band saw and drill press the whole thing would've been better and easier to build, but as it was a coping saw, cordless drill, and table saw with clamps here and there sufficed.
I'll let the picture speak for themselves.
Unfinished raw cedar so the smell permeates the brush
The whole thing is now heading overto my brother as a PIF - I'm trying to convert him to wetshaving..
I've always liked wood, but the options were limited and I picked up the Col Conks one from Amazon.
While it works, the rear trench for the razor wasn't big enough, and I'd wanted it on a tilt to better keep the razor in place.
So without further ado, I set out to match what came in the mail, from some fallen cedars in my yard.
A bit chunkier, but I think it does the trick.
If I had a band saw and drill press the whole thing would've been better and easier to build, but as it was a coping saw, cordless drill, and table saw with clamps here and there sufficed.
I'll let the picture speak for themselves.
Unfinished raw cedar so the smell permeates the brush
The whole thing is now heading overto my brother as a PIF - I'm trying to convert him to wetshaving..
Last edited by a moderator:
tweezerman for life
