I'm looking to get some washers to prevent the marring of the finish on my razors. I expect to use them for my vintage Gillettes - Old Type, New Improved, Goodwill, New & Tech. The width needed sometimes is little more than where the handle meets the underside (Goodyear & New) or would look odd if it overshot the Tech "triangle" where the handle meets. My searches on this forum have found plenty of recommendations for the nylon M5, but I have more options:
M5x7.5mmx1mm
M5x10mmx1mm (most common)
M5x14mmx.08mm
M5x18mmx.09mm
Do you have a size recommendation between these for me? Also, hard or soft nylon?
M5x7.5mmx1mm
M5x10mmx1mm (most common)
M5x14mmx.08mm
M5x18mmx.09mm
Do you have a size recommendation between these for me? Also, hard or soft nylon?