Hi all,
I am getting into restoring razors. I have questions on what some reasonable tools would be for getting started. I would primarily be only using these for razor work so I don’t want to spend unnecessary funds on tools that will sit idle most of the time.
For cutting scales: I have been wondering if a coping saw is sufficient, or if buying a small band saw is in order. What do you guys use? I have a garage but limited space so it would need to be something small.
For drilling pin holes: I could get a cheap, small table top press for fairly cheap. But I also have a Dremel and wonder if the little press pictured below would be a good buy? Do any of you use it?
Thx for the help!
Sent from my iPhone using Tapatalk
I am getting into restoring razors. I have questions on what some reasonable tools would be for getting started. I would primarily be only using these for razor work so I don’t want to spend unnecessary funds on tools that will sit idle most of the time.
For cutting scales: I have been wondering if a coping saw is sufficient, or if buying a small band saw is in order. What do you guys use? I have a garage but limited space so it would need to be something small.
For drilling pin holes: I could get a cheap, small table top press for fairly cheap. But I also have a Dremel and wonder if the little press pictured below would be a good buy? Do any of you use it?
Thx for the help!
Sent from my iPhone using Tapatalk