Handle Trouble

[GoldenBacon]

Hey guys, I am having a slight problem with my "Roll's Razor" handle. The box says it's the model with the telescopic handle and to "pull the handle" to make it extend. Try as I might, it just will not budge. Any suggestions on how to fix this?

This is a link to the model I have:
http://www.stropper.com/stropper_we...select2=&select3=&select4=&select5=&select6=0

Here are some pictures of said handle.

 

[tominabox1]

did you try to push? maybe it is already extended...

 

[michiganlover]

I don't know, that looks a lot like the handle that was with a Rolls set I just sold today. It's a one piece handle with a ball bearing in the part that slides over the blade. I am thinking that maybe your set had it's handle swapped at some point in time; these sets are quite old, so mismatches would seem to be somewhat frequent.

My current Rolls Razor handle is of a two piece design, and thus far easier to attach to the blade (unscrew handle to loosen, slide on to blade, re-tighten handle).

 

[GoldenBacon]

I don't know, that looks a lot like the handle that was with a Rolls set I just sold today. It's a one piece handle with a ball bearing in the part that slides over the blade. I am thinking that maybe your set had it's handle swapped at some point in time; these sets are quite old, so mismatches would seem to be somewhat frequent.

My current Rolls Razor handle is of a two piece design, and thus far easier to attach to the blade (unscrew handle to loosen, slide on to blade, re-tighten handle).

That would most likely be the case, thanks you.