Hi folks,
I've been looking at some of the other threads but wanted to see if I could home in a little bit on a specific question.
I have cleaned and polished the exterior of my Gillette Fatboy, and I'm really pleased with the results. But based on the the amount of surface material that I was able to clean and wipe off, and the state of my Sonicare toothbrush when I remove the head, I was considering the inside of the barrel.
I watched Captain Murphy's videos online and while I think I could manage the job, I don't really have a shop here to do the work.
I've considered a warm water soak, and maybe some compressed air.
Am I the only one that thinks about this, and if not, what other options are there, short of disassembling the razor?
Thx in advance for the advice.
I've been looking at some of the other threads but wanted to see if I could home in a little bit on a specific question.
I have cleaned and polished the exterior of my Gillette Fatboy, and I'm really pleased with the results. But based on the the amount of surface material that I was able to clean and wipe off, and the state of my Sonicare toothbrush when I remove the head, I was considering the inside of the barrel.
I watched Captain Murphy's videos online and while I think I could manage the job, I don't really have a shop here to do the work.
I've considered a warm water soak, and maybe some compressed air.
Am I the only one that thinks about this, and if not, what other options are there, short of disassembling the razor?
Thx in advance for the advice.