Well I look to the esteemed experts here at "The Nib" to answer my queries!!!! On my aerometric "51" how tightly should the feed assembly be in the converter? Mine is a loose slip fit. Thank you in advance for all of your help.
Tom
Tom
"51" Feed
- Thread starter airmech
- Start date
Paging brianw, brianw to the white courtesy telephone please.
He may be looking for a dropped "51" right now, I'm afraid to say.
He may be looking for a dropped "51" right now, I'm afraid to say.
Feed assembly should be snug but easily turned. If too loose will get a dripping out of hood.
- Thread starter
- #4
So how do I tighten up a loose one? A couple ounces of pressure to remove it.
Tom
Tom
Were you able to pull it straight out or did you have to give it a slight twist ? can you wiggle the feed and nib up and down while seated?
- Thread starter
- #6
It pulled straight out. I can't detect any appreciable wiggle in the nib assembly.
Tom
Tom
