I mentioned this SP101 sometime ago. It has been a test of my existing skills & an opportunity to learn some new ones. This is a parts gun made from a seperate frame & cylinder, trigger group, hammer & conversion cylinder with crane. Being a modern pistol, most parts were plug-n play, but not all.
The work I did:
*Hammer bob & polish
*Open the trigger face up to about 3/4" radius & polish
*Lower firing pin cup flush with frame
*Fit Bowen extra length firing pin
*Hammer & trigger cuts squared
*Hammer & trigger shims added
*Cranes & cylinders individually fit for endshake using bearings
*Trigger guard modified with forward set- screw for quick change 9mm to .38/.357 swap
The work I did not do:
*Conversion cylinder chambered for all nominal .355-.357 rounds
*Milled for full moon clips both by Pinnacle High Performance
*J-frame rear sight groove milled & fit
*Matched with higher Tru-glo TFO front fiber optic/tritium both done by Briley Mfg.
The result:
The work I did:
*Hammer bob & polish
*Open the trigger face up to about 3/4" radius & polish
*Lower firing pin cup flush with frame
*Fit Bowen extra length firing pin
*Hammer & trigger cuts squared
*Hammer & trigger shims added
*Cranes & cylinders individually fit for endshake using bearings
*Trigger guard modified with forward set- screw for quick change 9mm to .38/.357 swap
The work I did not do:
*Conversion cylinder chambered for all nominal .355-.357 rounds
*Milled for full moon clips both by Pinnacle High Performance
*J-frame rear sight groove milled & fit
*Matched with higher Tru-glo TFO front fiber optic/tritium both done by Briley Mfg.
The result:
Last edited: