Trying to see how far I can push the edge on this Cape 2000 while only using a slurry generated from a not so worn out Atoma 1200
What did you hone today?
- Thread starter ouch
- Start date
These needed a total overhaul - lotsa swarf on the 1k Gouken Arata. finished on a Trans Ark.
These needed a total overhaul - lotsa swarf on the 1k Gouken Arata. finished on a Trans Ark.
Too fine and they will push hair instead of cut it.
Shoulderless Wade, 6/8, half-hollow. Dialed this one up for tonights shave. Yum.
Zubora Kamisori. It didn't want to play nice with a Ark finisher.
I honed so much yesterday my fingers bled. It was a good day.
Still waiting for that axe Boker.Shoulderless Wade, 6/8, half-hollow. Dialed this one up for tonights shave. Yum.
Okudo Suita jnat.
Thanks. Took me a long time to get a stone like this.
Did a quick bevel reset on a C-Mon HF with a slurried Shapton 4k then a nagura progression on a Kiita to finish, we will see how it shaves tomorrow as I have honestly not spent much time with this finisher
A little old school JNAT and old stub tail. Think it says PRYOR, but that o maybe like a u symbol and the last one maybe a symbol or just an off stamp. Can’t fully tell.
NOS Hart with Lacewood scales. Initials "BG" are on the other side of the tang. Trying her out tomorrow.
My first post in this topic.
Hannover razor, refresh the edge with DN slurry on my Jnat and finished with Light tomo slurry. Shave test today.
Near wedges are tough to hone.... well for me! [emoji12] took me 30 minutes...
Sent from my iPhone using Tapatalk Pro
Hard steel plus a hard Ark equals a lot of time, but the edge can be wicked!
What do you think of that stone?
Still sorting it out. Decent edges, it's capable of finishing but not at all sure I am getting the most out of it. Doing lots of honing, different razors, water, water and soap, slurry, no slurry ect.
Do you have any suggestions.
Another day, another bevel - Wosty Rockingham IX-L. The pic is after pinning, before the 1k.
Similar threads
