Frameback repair.

[straightrazorheaven]

Hey Guys,

It's been a while since I posted (been busy) but I was quite proud of this one.
It took me a little while to figure out that this was a frame back, once I did I set about mending it.


Showing the brass tube here.

Cut to size, and shaped using my jewelers anvil and hammer.

Fitted to the blade ready to buff to the correct fitment.

The Buffing wheel and a little heat form that really fits the frame tightly to the blade.

Finished job

 

[Gamma]

Nice!

 

[straightrazorheaven]

Thanks

 

[JGKC9AYC]

I'm sure someone's going to ask eventually, so i'll go ahead.
What'd you pay for that? Darn nice looking straight!