Hi guys, forgive me if this might have already been covered. Last great I bought a relatively cheap SR from a popular auction site which came from China. I wasn't expecting much just something I could practice honing on. It was a ZY razor called Poseidon.
Instead of having the normal brass pinning out had some sort of abomination consisting of Phillips screws that held the razor and scales in place. Ultimately whenever I opened the razor the scales would become extremely loose. They couldbe tightened but would not stay rtight.
So....I bought some new scales and have cut the old scales off with a Dremel because those screws would not come out...at all. Here's where I would appreciate some wise advice.
Can I fill the pin hole that is much larger in diameter than the brass rod with epoxy? If so do I just need to sand that flat and drill a proper diameter hole in said epoxy filled hole and go about peening as usual?
Thank you for your help!
Instead of having the normal brass pinning out had some sort of abomination consisting of Phillips screws that held the razor and scales in place. Ultimately whenever I opened the razor the scales would become extremely loose. They couldbe tightened but would not stay rtight.
So....I bought some new scales and have cut the old scales off with a Dremel because those screws would not come out...at all. Here's where I would appreciate some wise advice.
Can I fill the pin hole that is much larger in diameter than the brass rod with epoxy? If so do I just need to sand that flat and drill a proper diameter hole in said epoxy filled hole and go about peening as usual?
Thank you for your help!