Hello guys,
Good morning
a few weeks ago i bought a nice wooden shaving brush handle from an Us artisan, iam from europe.
I apologize in advance for any writing mistakes,.
Since this is the first time glueing a knot into a handle for me i have a few questions,
it seems that the glue to go for is 2 component epoxy glue right?
Are all 2K Epoxy glues the same or is there something special to look out for while ordering ?
As far as of what i found out in my research,the best seller for "cheaper" solid quality badger knots is Oumo.
The diameter in the wooden handle is 26mm,so what knot size do u think i should order?
can a 26mm Brush knot fit or do i need a smaller one? Or is oumo selling the knots "smaller" so a 26mm is a little bit smaller and will fit a 26mm hole?
ive found many opinions on the internet and of course it depends on many factors,
but it would be great to hear what size u recommed,so i dont make a big mistake.
thanks in advance
greetings
Good morning
a few weeks ago i bought a nice wooden shaving brush handle from an Us artisan, iam from europe.
I apologize in advance for any writing mistakes,.
Since this is the first time glueing a knot into a handle for me i have a few questions,
it seems that the glue to go for is 2 component epoxy glue right?
Are all 2K Epoxy glues the same or is there something special to look out for while ordering ?
As far as of what i found out in my research,the best seller for "cheaper" solid quality badger knots is Oumo.
The diameter in the wooden handle is 26mm,so what knot size do u think i should order?
can a 26mm Brush knot fit or do i need a smaller one? Or is oumo selling the knots "smaller" so a 26mm is a little bit smaller and will fit a 26mm hole?
ive found many opinions on the internet and of course it depends on many factors,
but it would be great to hear what size u recommed,so i dont make a big mistake.
thanks in advance
greetings