Well after months of debating and going back and forth between which full sized brush I wanted next and many PM's and questions to B&B's brush expert "edgerunner", I finally decided on a stock Shavemac #25 26mm Silver Tip Badger Shaving Brush from WCS.
I knew going in it would be big, but I had no idea it would be so beautiful, the engraving, the handle heft and shape, the knot. It screams perfection. The knot is approximately 28mm at top of the handle, which I knew it would be, as stock measurements from Shavemac are apparently at the base of the actual knot, so up a bit from where it's set is obviously larger.
If all goes well, and I'm sure it will, this will not be my last Shavemac.
Here are a few shots, pre, lathered and post with some new PdP that also arrived today.
Pre/Out of the box:
After 30sec of lathering on PdP:
After bowl lathering:
Post bloom (still damp):
I knew going in it would be big, but I had no idea it would be so beautiful, the engraving, the handle heft and shape, the knot. It screams perfection. The knot is approximately 28mm at top of the handle, which I knew it would be, as stock measurements from Shavemac are apparently at the base of the actual knot, so up a bit from where it's set is obviously larger.
If all goes well, and I'm sure it will, this will not be my last Shavemac.
Here are a few shots, pre, lathered and post with some new PdP that also arrived today.
Pre/Out of the box:
After 30sec of lathering on PdP:
After bowl lathering:
Post bloom (still damp):