What did you use to hold the blade while you used the Dremel. Obviously it needs to be secure and also not damage the cutting surface.
I agree. Cut away the bulk of the metal (easy enough with the right scissors) and finish with the Dremel. Not that I know for sure, but it makes sense to me for the reasons you mentioned, and it should be easier, too.
Happy shaves,
Jim
Hey Jim,
I just held it pinched between thumb and index finger on the opposite end I was working on. When using the Dremel, I was very careful to only allow light contact sufficient for removing a very small amount of metal.
My success rate for getting a perfect fit on the first try with scissors alone is somewhere around 50%, but with a Dremel that goes up to virtually 100%.