Removing soap that was milled into container.

[Kyle Hyde]

I had posted this in the Soaps forum, but thought I might get more suggestions here.

I milled a soap (provence sante) into a container and now I would like to remove it. Is there anyway to do that without using all the soap first?

 

[machine99703]

Heat up the container a bit, use hot water. Shouldn't take much.

 

[Sodapopjones]

I just use a butter-knife, but then again thats with Williams haha.

 

[mdunn]

i had to do this.

I bent a paperclip and slid one end (that is to say, a piece of wire) around the outside, then i put the container upside down and slapped it a few times, the soap just popped out

 

[chainfire]

Heat up the container a bit, use hot water. Shouldn't take much.

+1 That would be what I'd think too...either a double boiler idea or nuke it for a couple seconds?

 

[RBE17]

I did this once and just used a butter knife and spoon. I was throwing the soap away so how it came out didn't matter.

 

[Razor&Pens]

Put it in the freezer for a little while. At least that's what I've read the soap makers suggesting.