Just a couple of short blasts... anyone think why it might be bad?
compressed air works great to dry pivot
- Thread starter global_dev
- Start date
Should work, but if it gets cold it might cause condensation.
That looks like an enema tip-yikes.
Ahh - the Giottos Rocket Blower. They come in 3 sizes - that looks like the #1910.
That's just cool looking. How long do they last? and is it like cheese in a can, you just push the nozzle to the side and it blows?
You squeeze it and air is forced out of the nozzle.
I sometimes get lather in there when I shave/cut the sides of my goatee with the heel of the blade.
It is actually used to clean dust from cameras and such, but works nicely to blow out water from scales, water from the inside of Feather AC's, etc.
It is actually used to clean dust from cameras and such, but works nicely to blow out water from scales, water from the inside of Feather AC's, etc.
- Thread starter
- #12
i didn't think it was getting wet, i barely use water to clean off the blade, but low and behold a bit of water in that area. not quite sure... i am pretty careful to rinse the blade at an angle that wouldn't allow water anywhere near the pivot... and my home is pretty dry, so i would think it wasn't necessary, but... better safe than sorry.
Rust in the pivot area? That's what replacement scales are for... ;-)
