I'm not sure if this is the right place to put this Thread?
Here goes. Some of you older folks might remember the Single Cup Heater Element for heating water in a cup? Used for Tea or coffee, boil water, etc.
I tried using it years ago and burned up the 'element' when I left it in a cup cup of water and went and took my shower. Which usually takes me 10 - 15 minutes.
In that short amount of time it took to shower, the H2O boiled off and the heating element burned up.
Fast forward to now. I tried it again, only this time I unplug the element prior to my shower. LOL!
When I get out of the shower, I plug it back in. I apply my Proraso Pre-Shave and leave on for a couple of minutes. By the time everything is ready I have nice hot water for my Scuttle. It creates a nice, thick, warm Proraso Green foam. The Scuttle retains the heat perfectly.
I know boiling water will destroy the foam, so I'm very aware not to get the water to the boiling point.
It works for me. JMHO, YMMV.
b/r
ON_1
Here goes. Some of you older folks might remember the Single Cup Heater Element for heating water in a cup? Used for Tea or coffee, boil water, etc.
I tried using it years ago and burned up the 'element' when I left it in a cup cup of water and went and took my shower. Which usually takes me 10 - 15 minutes.
In that short amount of time it took to shower, the H2O boiled off and the heating element burned up.
Fast forward to now. I tried it again, only this time I unplug the element prior to my shower. LOL!
When I get out of the shower, I plug it back in. I apply my Proraso Pre-Shave and leave on for a couple of minutes. By the time everything is ready I have nice hot water for my Scuttle. It creates a nice, thick, warm Proraso Green foam. The Scuttle retains the heat perfectly.
I know boiling water will destroy the foam, so I'm very aware not to get the water to the boiling point.
It works for me. JMHO, YMMV.
b/r
ON_1