Made a few and keep forgetting to post them up. Had to take some larger limbs off of a trident maple I planted about 17 years ago. Took the opportunity to knock a few things out on the lathe including this handle.
I almost dyed it. Have quite a bit of the maple so may mix up some aniline dyes and goof around. This one is only bored at ⅞” so 20-22mm knot. I don’t normally get knots smaller than 24mm so not sure if I well ever use it or not.
Correction: not rosewood dye, it was a walnut. The blue is kind of weird and holographic with the grain in person. Will be interesting to see with CA finish later