This Shavemac 24 mm knot was supposedly set at a 50mm loft, but it measures closer to 47-48. The knot is smaller than it appears and has not bloomed after many uses. I like a knot with backbone, but wish this had been set a bit higher so it would splay more easily.
I need advice on the best way to remove and reset this knot without damaging the knot or handle.
Questions:
1. If I do it myself, what’s the best way to remove the knot without damaging the knot or handle?
2. Can you recommend any vendors who would do this for me at a reasonable price so I don’t screw it up?
Thanks, guys.
I need advice on the best way to remove and reset this knot without damaging the knot or handle.
Questions:
1. If I do it myself, what’s the best way to remove the knot without damaging the knot or handle?
2. Can you recommend any vendors who would do this for me at a reasonable price so I don’t screw it up?
Thanks, guys.