Is there a way to keep the decal?

[Luc]

I got a nice straight and I like the decal on the blade. Is there a way to restore the blade without removing the decal? I'm assuming that a blade with pitting spots will need sanding and only sanding can remove those spots. Sanding might remove the decal also, any thoughts?

Pictures to follow if required!

 

[mdunn]

is it etched or engraved?

(pics! pics!)

 

[Luc]

is it etched or engraved?

(pics! pics!)

etched.

Hang on, upload in progress!

 

[Luc]

Here we go. I'm not even sure of the word in there... I should revive the Russian straight thread (Yes, that's a Stiz)

 

[Luc]

Should I use chemicals instead to clean the blade?

 

[leighton]

IMO, the rust is too bad. However, you might be able to save it using the tumbler method. I'm sure someone in your city has a tumbler. Apparently they're more common than I think.

 

[Luc]

IMO, the rust is too bad. However, you might be able to save it using the tumbler method. I'm sure someone in your city has a tumbler. Apparently they're more common than I think.

Just had a look at the tumbler method... (http://www.straightrazorplace.com/forums/workshop/18075-new-idea-experimentation-3.html)

Wow! Impressive! I'm unsure if I can get that over here, I will need to make some inquiries... Thanks for that mate!

 

[Sticky]

It could be photographed and/or laser/acid etched. IIRC, Traveller over at SRP has done this before. I think Joe Chandler has also. My guess is that it would be expensive.

 

[DunEdinRanger]

Just had a look at the tumbler method... (http://www.straightrazorplace.com/forums/workshop/18075-new-idea-experimentation-3.html)

Wow! Impressive! I'm unsure if I can get that over here, I will need to make some inquiries... Thanks for that mate!

That was impressive. I wonder if it would work with DE's?

 

[Seraphim]

That was impressive. I wonder if it would work with DE's?

Probably not, as most DEs are chrome plated, and I'd imagine that the tumbler would simply remove the plating, leaving you with a shiny brass DE.

 

[Scissors]

FWIW, the tumbler used is for sale here, and its not expensive:

http://www.midwayusa.com/viewProduct/?productNumber=587176

I don't know about shipping out of the US, though.

Edit to add: int'l info is here:

http://www.midwayusa.com/General.mvc/Index/international_information

You'd have to order from an Australian reseller. As of right now, they don't have one, but you may be able to find similar products.

 

[Luc]

Thanks for the information!

I will keep looking but I might send this one to be restored... I'm unsure yet. I would love to keep the design on the blade but I guess you can't have everything all the time...

 

[Cedrck]

Though it a shallow “frost” It can be saved, and look original as from factory… but it’s a lot of work, and only worth it if it’s a heirloom or something special, otherwise you may want to go the tumbler rout.
I don’t have much experience with tumblers, but I believe when finished it will look different but still there… better than sanding.