Hello everyone, One of my SR was beginning to tug and cause irritation so I decided I would try to rehone it. I recently purchased a Cnat for this purpose.
I lapped the stone and went to work doing what I have watched from others online (zero pressure with free flowing water) for about 100 or so passes... Went to test it and it's duller then before? Won't even cut the hairs on my arm
I'm not one to blame hardware because I'm sure I'm the one at fault, but I really could use advice on where to go from here.
I have a small dubl duck dry hone (maybe 2x4) and the Cnat mentioned previously. I was thinking to grab an 5k and 12k synthetic and maybe start back on the 5k to see if I can sharpen this edge...
What would be your next move?
TIA
I lapped the stone and went to work doing what I have watched from others online (zero pressure with free flowing water) for about 100 or so passes... Went to test it and it's duller then before? Won't even cut the hairs on my arm
I'm not one to blame hardware because I'm sure I'm the one at fault, but I really could use advice on where to go from here.
I have a small dubl duck dry hone (maybe 2x4) and the Cnat mentioned previously. I was thinking to grab an 5k and 12k synthetic and maybe start back on the 5k to see if I can sharpen this edge...
What would be your next move?
TIA