What's new

First lathe turning/First handle

I decided that I wanted to try my hand at lathe turning. First I had to make a lathe, using a drill motor.

The handle is natural buffalo horn that is basically black, but with light streaks of white.
I wanted this to be travel brush, so I went with an 18mm silvertip grade A knot from TGN.

The handle before being polished.



The finished brush.



I learned a lot about turning, and I'm ready to try another handle.
 
I decided that I wanted to try my hand at lathe turning. First I had to make a lathe, using a drill motor.

The handle is natural buffalo horn that is basically black, but with light streaks of white.
I wanted this to be travel brush, so I went with an 18mm silvertip grade A knot from TGN.

The handle before being polished.



The finished brush.



I learned a lot about turning, and I'm ready to try another handle.

Excellent work. Brush is looking good.


Would you show us a photo of how you set up your drill?
 
The drill motor setup: The critical things are to get the chuck level to the working surface and square to some reference line.


 
Top Bottom