Disassemble, wiped down, razor goes back in stand. I don’t store the razor with the blade. I have grandkids roaming around at any given notice and therefore, don’t keep the blade in the razor. The blade goes on a magnetic disk that’s adhered to the top of my mirror.
Do you take apart your razor to clean it after every shave?
- Thread starter shave/brush
- Start date
For every shave, disassemble the razor, remove the blade, thoroughly rinse all the razor parts and blade under hottest tap water. Then pat dry the blade, hand dry the parts with a dry towel and lay them all on a microfiber towel to air-dry until the next shave.
BTW, this method (without any polishing) has produced a beautiful, even, non-splotchy patina on my brass Karve Overlander!
BTW, this method (without any polishing) has produced a beautiful, even, non-splotchy patina on my brass Karve Overlander!
Yes..
About the same as above.
ABC's of maintenance..
BFX
If you take care of stuff properly, they normally will last longer...
About the same as above.
ABC's of maintenance..
BFX
If you take care of stuff properly, they normally will last longer...
I do not. I hot water rinse after every shave, then disassemble/clean/dry when I change blades(every third shave).
Ill give it a good rinse under hot water but that's about it
After every shave, I take the shaver apart and clean it with a toothbrush and dish soap. Then I let it dry for a few hours and store it disassembled.
I don't know if that's right, but it's nice and clean and fresh.
I don't know if that's right, but it's nice and clean and fresh.
Similar threads
