I have a few ER 100 brushes I would really like to restore some depth to certain letters which are worn off from time or accidentally sanded down during restore.
I am concerned using a Dremel with extremely small/fine bits is too risky for such fine work, but again that is how engraving is done, right?
Here is a link to a picture of some very small and fine bits I think might work on the various Font sizes on the handle, but dont know if they would only work with an engraving tool or if you could do it by hand.
http://i.imgur.com/iYZeY8e.jpg
Thoughts, comments, experience?
I am concerned using a Dremel with extremely small/fine bits is too risky for such fine work, but again that is how engraving is done, right?
Here is a link to a picture of some very small and fine bits I think might work on the various Font sizes on the handle, but dont know if they would only work with an engraving tool or if you could do it by hand.
http://i.imgur.com/iYZeY8e.jpg
Thoughts, comments, experience?