I can't read the "made in" info.
thanks
thanks
Any idea what this gillette razor head is ?
- Thread starter Hex
- Start date
Made in U.S.A. Ball end Old Type.
...with some seriously bent teeth.
Im guessing it is from a Single Ring since the neck is connected to the head.
+1 on single ring
+2. Def. a single ring. Ball ends don't have the neck attached to the baseplate.
Yep, you guys are right about the single ring. I was thinking it was the top part of a ball-end, threaded on... but the cap isn't there to thread on to! 
+3 it's also made out of brass.
Those two teeth aren't bent that badly. If one were wanting to and could find a handle and top piece to fit it, you probably could actually shave with it. I would bet that it would be quite aggressive, though.
