@ylekot show us a pic of your setup
I doubt it but maybe it’s something obvious to others that prevents success.
I doubt it but maybe it’s something obvious to others that prevents success.
Oneblade also has a hot foam dispenser, you might be tied into just their soaps possibly? They work because a few folks on this forum use them. I will just keep using my ceramic bowl until I do not want to, I have back ups already if I break it.I prefer your method but if you want hot gooo
Best Shaving Cream Warmer (Dispenser) Reviewed [2022 ]
Want a barbershop quality shave cream but don't feel like whipping up a lather? The best shave cream warmers can make all the difference in comfort for you!www.toolsofmen.com
for me I dunk my ceramic or stone bowl with my razor and brush in a hot sink while soaking my face under a hot towel.
Apologies, "gosh" I had some good enjoyment reading this information and differences + different methods of generating lather. Shaving is a learning curve for us all because a lot of us were never taught this wet shaving tradition on how to properly shave even with a cartridge razor and goo(I always liked Gillette gel).Actually I was using the Arko to try to learn how to do this before ruining the sample of "good" soap that I have. I made several attempts over the course of a rainy day using varying amounts of soap/water and so I went through quite a bit in multiple attempts and I used what I thought was finally a decent lather. It didn't work and I am extremely frustrated at my inability to succeed at what seems like such simple task. My apologies for being ridiculous as I vent about my trials and tribulations trying to learn how to do this. No one forced you to read it, or reply. Perhaps you need to block me so you won't waste 5 minutes of your time again.
@ylekot show us a pic of your setup
I doubt it but maybe it’s something obvious to others that prevents success.
Much to happy with my stirling, a&e, b&m to consider goo againOneblade also has a hot foam dispenser, you might be tied into just their soaps possibly? They work because a few folks on this forum use them. I will just keep using my ceramic bowl until I do not want to, I have back ups already if I break it.
Not the easiest to start with.Mug is 4 inches across by 3 1/2 inches high, bamboo bowl is 3 1/4 inches across by 2 inches deep. Brushes are a Vie-Long Peleon and a Simpson's Wee Scot.
How about facelathering before going back to the can?
Captain's Choice has always been my most favourite lather bowlNot the easiest to start with.
I would use the mug to drop a puck into it or press the remainder of the Arko stick in. This could be your loading bowl. The bamboo bowl might work with the Wee Scot as it looks quite small yet the Wee Scot is more suited to face lathering.
A shallow and wide salsa bowl liberated from the kitchen might make life easier for you. Some kind of ridges/knobs/etc. ditto.
View attachment 1323602
View attachment 1323603
the Timeless bowl is budget friendly and very well regarded here.
View attachment 1323604
@Ron R showed a sauce pan with epoxied coins that work great. I use this setup in a Turkish barber bowl (top view bottom right). @Ivo4u2 has a Suribachi mortar with fine ridges that help building the lather.
I guess your choice of equipment makes it harder to achieve a fine lather then it ought to be.
OK so my gear may not be up to snuff for starting out. The Wee Scot is excellent for face lathering (even I can do it!)Not the easiest to start with.
I would use the mug to drop a puck into it or press the remainder of the Arko stick in. This could be your loading bowl. The bamboo bowl might work with the Wee Scot as it looks quite small yet the Wee Scot is more suited to face lathering.
A shallow and wide salsa bowl liberated from the kitchen might make life easier for you. Some kind of ridges/knobs/etc. ditto.
View attachment 1323602
View attachment 1323603
the Timeless bowl is budget friendly and very well regarded here.
View attachment 1323604
@Ron R showed a sauce pan with epoxied coins that work great. I use this setup in a Turkish barber bowl (top view bottom right). @Ivo4u2 has a Suribachi mortar with fine ridges that help building the lather.
I guess your choice of equipment makes it harder to achieve a fine lather then it ought to be.
…To each their purpose, and lather from same dependent on 4 basic things:
Water, air, soap, and skill.
Roughly in order of importance. Soft water helps, the right brush helps, the right soap helps, and experience counts. Some here can make lather from a plastic poker chip, in the Sahara, with a spoon and lizard spit. Point being, you can vary all of those things with software, hardware and practice, to get the result you want.…
I am in love with that aged copper bowl he revealed a few days ago! I think I will try to master what I have first.Captain's Choice has always been my most favourite lather bowl
If that one is in your budget than you are in for a treat. My CC works marvelously.I am in love with that aged copper bowl he revealed a few days ago!
I am in love with that aged copper bowl he revealed a few days ago! I think I will try to master what I have first.
Captain's Choice lather bowl is the holy grail in my den, because, the height of the bowl is PERFECT!!! without all that banging, clanging, and dinging noises side to side when building up a lather, that GIVES ME PEACE!!!If that one is in your budget than you are in for a treat. My CC works marvelously.
Yes, I did notice that my mug is a bit too tall and the brush handle will clank, I switched to the bowl to try to eliminate that, maybe a bigger bowl?Captain's Choice lather bowl is the holy grail in my den, because, the height of the bowl is PERFECT!!! without all that banging, clanging, and dinging noises side to side when building up a lather, that GIVES ME PEACE!!!
Yes, wider and more shallow as in the pics…Yes, I did notice that my mug is a bit too tall and the brush handle will clank, I switched to the bowl to try to eliminate that, maybe a bigger bowl?
As long as the wider Captain's Choice bowl fits comfortably in your hand, IF not, just get the standard diameter.Yes, wider and more shallow as in the pics…
I have gotten some advice here that I am going to try. And I will definitely continue to face lather. It just seems like this should be so simple, but others have chimed in saying they are not very good at it either. Is this one of those deals where you yo have an "A HA" moment and it all just falls into place?@ylekot says he quit, a d I understand. I spend more time on lathering than any other component. I enjoy the time spent, however, and the whole shave is delightful.
for me it's patience and practice. I've been doing it for a decade and it's very luxurious these days.I have gotten some advice here that I am going to try. And I will definitely continue to face lather. It just seems like this should be so simple, but others have chimed in saying they are not very good at it either. Is this one of those deals where you yo have an "A HA" moment and it all just falls into place?