I bought this slightly used Wacker 7/8 in bone, and received a discount because the blade was offset. Photo below will show it.
Ideas on how to fix this problem appreciated.
Note that the spacer is glued in place, unfortunately. That means I am reluctant to pry it out,
as that could fracture the whole bone scale. Yeah, the pinning makes you think it's not glued, as why even use a pin? But it is glued.
All I can think of is taking a dremel and carefully cutting out the whole spacer, then pin in a fat one, to create a wide enough gap to miss the edge?
Maybe I go back to the pivot and somehow change the geometry back there?
This will be my first scale project, so I'm a beginner here. But it's a very good razor, so I'm determined to fix it. If it's a special tool issue, I'm willing to mail it to a pro.
thanks in advance.
Ideas on how to fix this problem appreciated.
Note that the spacer is glued in place, unfortunately. That means I am reluctant to pry it out,
as that could fracture the whole bone scale. Yeah, the pinning makes you think it's not glued, as why even use a pin? But it is glued.
All I can think of is taking a dremel and carefully cutting out the whole spacer, then pin in a fat one, to create a wide enough gap to miss the edge?
Maybe I go back to the pivot and somehow change the geometry back there?
This will be my first scale project, so I'm a beginner here. But it's a very good razor, so I'm determined to fix it. If it's a special tool issue, I'm willing to mail it to a pro.
thanks in advance.